LCT- Installation with rivets

1. You can use the tracker as a drilling template,

2. Mounting with rivets: e.g., 2 pieces Bralo Multigrip Ø 4.8 x 16.5 for aluminum/steel sheet – clamping range 6.5-12.5 mm. Suitable for a maximum material thickness of 5.5 mm.

NOTE: Due to the dead weight of the Low Cost Tracker, mounting using tape is not recommended.

PreviousLCT- Installation with screws NextLow Cost Tracker- Device Transport Rules

Last updated 5 months ago

Was this helpful?